Boot Methods (Linux in a Nutshell, 3rd Edition)

4.1. The Boot Process

Once your Linux system is up and running, booting the system generally is pretty straightforward. But with the wide variety of hardware and software in use, there are many possibilities for configuring your boot process. The three most common choices are:

Boot Linux from a floppy, leaving any other operating system to boot from the hard drive.

Use the Linux Loader, LILO.[2] This is probably the most common method of booting and lets you boot both Linux and other operating systems.

[2]LILO is the standard boot program for i386-architecture machines. On the Alpha, the equivalent boot program is called MILO (Mini Loader), and on the SPARC, it is SILO.
Run Loadlin, which is an MS-DOS program that boots Linux from within DOS.

Other boot managers that can load Linux are available, but we don't discuss them in this chapter. We also won't talk further about booting from a floppy except to say that whatever method you choose for booting, you should be sure to have a working boot floppy available for emergency use. In particular, don't experiment with the files and options in this chapter unless you have a boot floppy, because any error could leave you unable to boot from the hard disk.

On an Intel-based PC, the first sector of every hard disk is known as the boot sector and contains the partition table for that disk and possibly also code for booting an operating system. The boot sector of the first hard disk is known as the master boot record (MBR), because when you boot the system, the BIOS transfers control to a program that lives on that sector along with the partition table. That code is the boot loader, the code that initiates an operating system. When you add Linux to the system, you need to modify the boot loader, replace it, or boot from a floppy disk to start Linux.

In Linux, each disk and each partition on the disk is treated as a device. So, for example, the entire first hard disk is known as /dev/hda and the entire second hard disk, if there is one, is /dev/hdb. The first partition of the first hard drive is /dev/hda1, and the second partition is /dev/hda2; the first partition of the second hard drive is /dev/hdb1; and so on. If your drives are SCSI instead of IDE, the naming works the same way except that the devices are /dev/sda, /dev/sda1, and so on. Thus, if you want to specify that the Linux partition is the second partition of the first hard drive (as in the examples in this chapter), you refer to it as /dev/hda2.

The rest of the chapter describes the various techniques for booting Linux and the options that you can specify to configure both the boot loader that you use and the Linux kernel. Both LILO and Loadlin let you pass options to the loader and they also let you specify options for the kernel.

Chapter 4. Boot Methods

Contents:

4.1. The Boot Process


3. Linux Commands		4.2. LILO: The Linux Loader