Problem

You need to copy a file, but Perl has no built-in copy command.

Solution

Use the copy function from the standard File::Copy module:

use File::Copy; copy($oldfile, $newfile);

You can do it by hand:

open(IN,  "< $oldfile")                     or die "can't open $oldfile: $!"; open(OUT, "> $newfile")                     or die "can't open $newfile: $!";  $blksize = (stat IN)[11] || 16384;          # preferred block size? while ($len = sysread IN, $buf, $blksize) {     if (!defined $len) {         next if $! =~ /^Interrupted/;       # ^Z and fg         die "System read error: $!\n";     }     $offset = 0;     while ($len) {          # Handle partial writes.         defined($written = syswrite OUT, $buf, $len, $offset)             or die "System write error: $!\n";         $len    -= $written;         $offset += $written;     }; }  close(IN); close(OUT);

Or you can call your system's copy program:

system("cp $oldfile $newfile");       # unix system("copy $oldfile $newfile");     # dos, vms

Discussion

The File::Copy module provides copy and move functions. These are more convenient than resorting to low-level I/O calls and more portable than calling system . move works across file-system boundaries; the standard Perl built-in rename (usually) does not.

use File::Copy;  copy("datafile.dat", "datafile.bak")     or die "copy failed: $!";  move("datafile.new", "datafile.dat")     or die "move failed: $!";

Because these functions return only a simple success status, you can't easily tell which file prevented the copy or move from being done. Copying the files manually lets you pinpoint which files didn't copy, but it fills your program with complex sysread s and syswrite s.

See Also

Documentation for the standard File::Copy module (also in Chapter 7 of Programming Perl ); the rename , read , and syswrite functions in perlfunc (1) and in Chapter 3 of Programming Perl