Problem

You need to compute the number of lines in a file.

Solution

Many systems have a wc program to count lines in a file:

$count = `wc -l < $file`; die "wc failed: $?" if $?; chomp($count);

You could also open the file and read line-by-line until the end, counting lines as you go:

open(FILE, "< $file") or die "can't open $file: $!"; $count++ while <FILE>; # $count now holds the number of lines read

Here's the fastest solution, assuming your line terminator really is "\n" :

$count += tr/\n/\n/ while sysread(FILE, $_, 2 ** 16);

Discussion

Although you can use -s $file to determine the file size in bytes, you generally cannot use it to derive a line count. See the Introduction to Chapter 9, Directories , for more on -s .

If you can't or don't want to call another program to do your dirty work, you can emulate wc by opening up and reading the file yourself:

open(FILE, "< $file") or die "can't open $file: $!"; $count++ while <FILE>; # $count now holds the number of lines read

Another way of writing this is:

open(FILE, "< $file") or die "can't open $file: $!"; for ($count=0; <FILE>; $count++) { }

If you're not reading from any other files, you don't need the $count variable in this case. The special variable $. holds the number of lines read since a filehandle was last explicitly close d:

1 while <FILE>; $count = $.;

This reads all the records in the file and discards them.

To count paragraphs, set the global input record separator variable $/ to the empty string ( "" ) before reading to make <> read a paragraph at a time.

$/ = '';            # enable paragraph mode for all reads open(FILE, $file) or die "can't open $file: $!"; 1 while <FILE>; $para_count = $.;

See Also

Your system's wc (1) manpage; the $/ entry in perlvar (1), and in the "Special Variables" section of Chapter 2 of Programming Perl ; the Introduction to Chapter 9